Photocell Outdoor Light Switch Daylight Dusk till Dawn Sensor Light switch,
Power Source:110-130V/AC 220-240V/AC
ØTo Install it to a flat surface, connect the plastic bracket to the photocell main body as indicated in Figure A. For pole mounting a gland or conduit connector can be screwed into the base of the sensor.
ØEnsure it is installed above the light fitting as indicated in the diagram
ØEnsure power is switched off.
ØConnect the wires as per the wiring diagram.
||Most wires, screws, etc.
||Water splashing against light enclosure from any direction has no damaging effect
||Test duration: 5 minutes
||Water volume: 10 litres per minute
||Pressure: 80100 kN/m